-
This appliance should only be repaired or serviced by an authorised
Service Engineer and only genuine approved spare parts should be
used.
SECTION 3. Installation of Ceramic Cooker :
This appliance must be installed by qualified personnel, according to
the manufacturer’s instructions and to the relevant Safety Standarts.
-
Electricity will be done to your cooker. Take care to make connetion
through the shortest way.
-
Remove all packaging, protective films and oils from the appliance
before installation.
-
Your appliance should always be fed by 230 V power. YOUR
APPLIANCE SHOULD DEFINITELY BE FED FROM AN EARTHED
SOCKET. Do not allow the electric cable of your appliance to contact
with the heated parts. When electric connection is made, position of
rotating switch shuld be at (0). Later let your appliance to operate idle
5-6 minutes by turning the switch to position (3).
-
Ensure that the electrical supply complies with the type stated on
the rating plate.
-
Do not attempt to modify the appliance in any way.
-
The place that you will install cooker must be at appropriate
dimensions.
-
Please be sure about your product to not have any damage on any
part of it after package opened. If you have any suspection about harm
of product, please contact with Authorised service and do not use the
product.
-
Your built-in cooker must be installed into a specially prepared
kitchen loom. Electrical connection of appliance will be done from
terminal box where is in bottom of product.
-
User of this product is responsible for installing and using product
according to instructions of this manual in all other conditions.
Placing Built-In Cooker
Cooker given with a special gasket to prevent any liquid leakage
under the kitchen loom. The dimensions of place where to install your
cooker is given in Figure 2 below.
Stick self-sticked gasket of your cooker from bottom of surface as to
cover ceramic glass from all around and locate the cooker to kitchen
loom with signal lambs are at front of cooker. Cooker fixed with help of
Figure 2
-
This appliance should only be repaired or serviced by an authorised
Service Engineer and only genuine approved spare parts should be
used.
SECTION 3. Installation of Ceramic Cooker :
This appliance must be installed by qualified personnel, according to
the manufacturer’s instructions and to the relevant Safety Standarts.
-
Electricity will be done to your cooker. Take care to make connetion
through the shortest way.
-
Remove all packaging, protective films and oils from the appliance
before installation.
-
Your appliance should always be fed by 230 V power. YOUR
APPLIANCE SHOULD DEFINITELY BE FED FROM AN EARTHED
SOCKET. Do not allow the electric cable of your appliance to contact
with the heated parts. When electric connection is made, position of
rotating switch shuld be at (0). Later let your appliance to operate idle
5-6 minutes by turning the switch to position (3).
-
Ensure that the electrical supply complies with the type stated on
the rating plate.
-
Do not attempt to modify the appliance in any way.
-
The place that you will install cooker must be at appropriate
dimensions.
-
Please be sure about your product to not have any damage on any
part of it after package opened. If you have any suspection about harm
of product, please contact with Authorised service and do not use the
product.
-
Your built-in cooker must be installed into a specially prepared
kitchen loom. Electrical connection of appliance will be done from
terminal box where is in bottom of product.
-
User of this product is responsible for installing and using product
according to instructions of this manual in all other conditions.
Placing Built-In Cooker
Cooker given with a special gasket to prevent any liquid leakage
under the kitchen loom. The dimensions of place where to install your
cooker is given in Figure 2 below.
Stick self-sticked gasket of your cooker from bottom of surface as to
cover ceramic glass from all around and locate the cooker to kitchen
loom with signal lambs are at front of cooker. Cooker fixed with help of
Figure 2
