Figure 15. Positioning an Installation Template on a vehicle’s inside rear
window so it aligns with outside registration marks.
12. When all four registration marks are aligned, press up along the Installation
Template’s boundary to secure adhesion to the window.
13. Without removing its protective backing, place the ThruGlass Coupler into
the template, as shown in Figure 16 below. The LED should turn on to indi-
cate that the antenna is properly passing RF signals and dc current through
the glass. If it does not turn on, slightly re-position the template until you find
a location that activates the LED.
Figure 16. Positioning the ThruGlass Coupler onto the inside Installation
Template. The coupler’s LED activates when position is correct.
14. With the template properly located, peel off the protective backing from the
ThruGlass Coupler. Starting with the front, carefully place the unit into the
template and, using steady pressure, firmly press the ThruGlass Coupler
down onto the glass for a minimum of 60 seconds, as shown in Figure 17 on
the next page.
Continued on next page...
Installation
11
TRK-SR1 I
NSTALLATION
G
UIDE
Inside
Template
ThruGlass
Coupler
LED
on
Outside
Template
Inside
Template
Outside
Template
TRK-SR1 Install Guide 8/29/01 9:06 AM Page 11
