Output Test Port::
Your amplifier comes with a test output port. Simply
connect a device to the F-connector marked “OUTPUT
TEST” to utilize this feature.
See fig. 2a.
Switchable Back-Channel Circuitry::
T2 amplifiers come with switchable, back-channel
circuitry. This means that your amplifier can pass signals
either one-way or bi-directionally. To select the proper
mode, choose the “CABLE” setting when using a cable
modem or any other bi-directional application. Choose
the “ANT” setting otherwise. Using the bi-directional
(CABLE) mode in conjunction with an antenna would result
in broadcasting the signal between 5 and 42 MHz, which is
a violation of FCC regulations.
See fig. 2b.
Note::
Amplifiers should be placed as close to the signal source
as possible, i.e. antenna, cable input, satellite dish, etc.
2
50%
Fig. 2
b
a
Features::
Introduction::
Thank you for purchasing this T2 Amplifier. T2 is the
brainchild of some of the most experienced professionals
in the custom installation and home entertainment
industries. Please read through this manual so that you
will know how to operate your amplifier properly, and
always keep it in a safe place for future reference.
Gain & Tilt::
Your amplifier has two knobs on the front, which should
be used to adjust the gain and tilt of your amplifier. Turn
the knob marked “GAIN” clockwise to increase the gain.
The other knob controls a built-in tilt compensator,
which proportionally decreases the gain at the lower
frequencies to compensate for the disproportionate signal
loss over cable at high frequencies.
It can simply be
rotated clockwise
from “TILT” to
“FLAT” based on
the individual
installation.
See fig. 1.
1
50%
Fig. 1
T0205-T2 amp-OM.qxp 9/16/03 09:38 AM Page C2
