terim TERCM1200PE, Инструкция по эксплуатации

Страница: 5 / 21

8. Leave the pump running until about half the water in the water container has
passed through.
9. Then switch off the pump by turning the operating dial to its neutral position.
10. Empty the cup and place it under the steam nozzle. Turn the operating dial to
position .
11. Water is now emitted through the steam nozzle.
12. Let the water pass through until the amount left in the container has reached the
‘Min.’ mark.
13. Switch off the pump by turning the operating dial to its neutral position.
14. This procedure should also be followed if the appliance has not been used for an
extended period of time.
Operation
Filling with water
• Fill only with fresh water on a daily basis; make sure that the water container is
cleaned at regular intervals. Do not switch the appliance on unless the water
container is filled.
* Lift up the water container lid and flip it back.
* Lift out the water container.
* Fill the container with (non-carbonated) cold water while observing the
‘Max’ marking on the water container.
* Once filled, replace the container in the appliance and push it down in order to
open the valve in the bottom.
* Close the lid on the water container.
• The water level must be monitored and, if necessary, the container refilled in good
time.
• If the pump have started sucking in air from the empty water container, fill the
water container first with the indicated maximum amount of water. When ‘filling’
the system afterwards, it may take a few moments before water is emitted
again.
• Deposits of dirt and lime may cause the seals in the outlet at the bottom of the