61
Operating Manual Crawler Excavator TC37
Working operation
6
6.3
Removing the cabin
For particular operations it is better to work without
cabin.
Removing the cabin
• Open the cabin door and engage in support.
• Remove the floor mat and the floor panel in front
of the seat console inside the cabin.
• Remove the front panel of the seat console, both
right-hand and left-hand side.
• Remove the rear cover.
• Loosen the cable connections leading towards the
cabin.
• Screw the crane lifting beam onto the cabin using
the 4 bolts.
• Remove the fastening screws (36/1 - 6 pcs.) with
washers (36/2) and nuts (36/5; remove nut only in
case of screwing 36/B).
• Unhinge the cabin using a crane and place it
carefully down onto the ground.
• Put on the canopy and fasten (tightening torque
M
A
= 59 lbf ft).
• Plug in the cable for the working floodlight(s).
• Re-install the rear cover, front panel and floor mat.
Fig. 36
Attachment of the cab
A) Screw (nut welded)
B) Screw and nut
0
4/4
h.
1
2
B
B
4
1
2
3
3
4
5
A
B
B
B
A
A
B
B
Attention
In order to dismount the cabin and to install
the canopy, the original Terex crane lifting
beam should be used (weight of the cabin
approx. 374.85 lbs).
Danger to life
due to falling objects.
• If you work without cabin, the canopy has
to be mounted.
Attention
For the removal of the canopy and re-
installation of the cabin, proceed in the same
manner as above but in reverse order.
