Terex RL4000D2, Руководство оператора, обслуживания и запасных частей

Страница: 17 / 68

November 2006
16 RL4000 Light Tower Part No. 833005 Rev A
OPERATING INSTRUCTIONS
STARTING THE ENGINE/GENERATOR SET
Insure the light switches are turned “ off” . This prevents the
engine from startin g under load and prevents electrical
equipment from being damaged.
1. Unlock and open the access doors.
2. Check the oil, fuel, and coolant levels.
3. Check that the tower has been properly grounded.
4. Preheat the unit for 10-30 seconds.
Never preheat for m ore than 30 seconds, damage may be
done to the heating elements.
5. Turn the switch towards the start side of the switch. On most units this is
towards the right.
To avoid s tart damage, never operate the starter fo r mor e
than 45 seconds.
5. Start the engine and listen for any unusual sounds or vibrations. Should unusual sounds
be detected, contact Terex Light Construction Service Manager.
6. Once the engine has been started and running smoothly, place the light switches in the
“ON” positions,
one at a tim e
.
7. Check each flood light for proper operation.
8. Close and latch the access doors.
Vaporous l ights r equire a warm u p period of 5-10 minutes
before they will produce a full output.