Terex Genie Z-60DC, Руководство оператора

Страница: 54 / 73

Operator's Manual
Second Edition • First Printing
Operating Instructions
52 Z
®
-
60 DC • Z
®
-60 FE Part No. 1307261GT
To determine the slope grade:
Measure the slope with a digital inclinometer OR
use the following procedure.
You will need:

carpenter’s level

straight piece of wood, at least 3 feet/1 m long

tape measure
Lay the piece of wood on the slope.
At the downhill end, lay the level on the top edge
of the piece of wood and lift the end until the piece
of wood is level.
While holding the piece of wood level, measure
the vertical distance from the bottom of the piece
of wood to the ground.
Divide the tape measure distance (rise) by the
length of the piece of wood (run) and multiply by
100.
Example:
Piece of wood = 144 inches (3.6 m)
Run = 144 inches (3.6 m)
Rise = 12 inches (0.3 m)
12 in ÷ 144 in = 0.083 x 100 = 8.3% grade
0.3 m ÷ 3.6 m = 0.083 x 100 = 8.3% grade
If the slope exceeds the maximum slope or side
slope rating, then the machine must be winched or
transported up or down the slope. See Transport
and Lifting section.
Drive Enable
Light on indicates that the boom
has moved just past either non-
steer wheel and the drive
function has been interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off
center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on
the platform controls and the drive chassis to
identify the direction the machine will travel.
Drive Speed Select

Machine on incline symbol: Low range for
improved throttle control at reduced drive
speed.

Machine on level surface symbol: High range
operation for maximum drive speed