Terex Genie Z-25J, Руководство оператора

Страница: 42 / 71

Operator's Manual
Sixth Edition • First Printing
Inspections
40 Z
®
-45/25J Part No. 1299167GT
Test Drive and Braking
29 Press down the foot switch.
30 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to
move, then return the handle to the center
position.
Result: The machine should move in the
direction that the blue arrow points on the
drive chassis, then come to an abrupt stop.
31 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
Test Drive Tilt Cutout
32 Press down the foot switch.
33 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 4.5°.
Result: The machine should continue to drive.
34 Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
35 Drive the machine onto a slope where the
chassis pitch angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.
36 Lower the primary boom to the stowed position
or drive in the opposite direction.
Result: The machine should drive.
37 Return to level ground and extend the primary
boom approximately 1.6 ft / 0.5 m.
38 Drive the machine onto a slope where the
chassis pitch angle is greater than 4.5°.
Result: The machine should stop once the
machine reaches 4.5° of chassis tilt and the
alarm should sound at the platform controls.