Terex Genie Z-135/70, Руководство по обслуживанию и ремонту

Страница: 106 / 244

Service and Repair Manual October 2018
Boom Components
92 Z®-135 /70 Part No. 1268557GT
22 Press and hold a function enable/speed select
button and the secondary boom up button until
the digital level displays 65 degrees.
23 At the ground controls, press the plus button
or minus button to adjust the display to the
exact value shown on the digital level and
press the
enter button.
Note: If the measured angle already matches the
angle shown on the display at the ground controls,
press the
plus button or minus button to change
the angle and then change back to the measured
value. The system must detect a change in
displayed value to record the calibrated value.
24 Press and hold a function enable/speed select
button and the secondary boom up button.
Fully raise the secondary boom. The boom is
fully raised when the cylinder is fully extended
and the boom stops moving.The angle will be
76 degrees.
25 At the ground controls, press the plus button
or minus button to adjust the display to the
exact value shown on the digital level and
press the
enter button.
Note: If the measured angle already matches the
angle shown on the display at the ground controls,
press the
plus button or minus button to change
the angle and then change back to the measured
value. The system must detect a change in
displayed value to record the calibrated value.
26 Press and hold the engine start button for
approximately 5 seconds to shut off the engine
and to save the calibration settings.
Note: Do not turn the engine off with the key switch
or red Emergency Stop button or all calibration
points or values will not be saved.
27 Press the enter or previous button on the
LCD screen until EXIT is displayed.
28 Press the plus button to select YES, then
press the enter button to accept.
29 Turn the key back to the run position and
remove the key from the bypass/recovery key
switch. Insert the key into the main key switch
and turn it to ground controls.
Note: Be sure that the bypass/recovery key switch
is in the run position before attempting to operate
the machine.
30 Wait approximately 20 seconds and turn the
machine off by pressing the red Emergency
Stop button in.
Before serial number 321:
31 Remove the wire jumper from the 2 pin
connector in the lower left hand area of the
ground control box that was installed in step 5.
Install the connector plug.
Tip-over hazard. Failure to
remove the jumper wire will
result in an unsafe configuration
which will compromise machine
stability. Operating the machine
in this configuration will result in
the machine tipping over,
resulting in death or serious
injury. The jumper wire must be
removed before operating the
machine.
32 Close the ground control box and install the
door retaining fasteners.