Terex Genie Load Lifter, Руководство по обслуживанию

Страница: 32 / 34

Service Manual September 2016
Winch A ssembly
24 Load Lifter Part No. 115415
9 Facing the winch side of the machine, thread
the cable through the winch mounting plate.
Pull all the cable through the plate.
10 Wrap the cable clockwise around the winch
drum. Attach the cable to the drum. Be sure
the end of the cable does not extend past the
edge of the winch drum.
11 While holding the cable tightly on the drum,
rotate the winch until all the cable is spooled
onto the drum. Be sure there are at least
4 wraps of cable on the winch drum.
Cable Routing
Note: The numbers on the illustration correspond to
the steps in procedure 1-4. Platform is raised for
illustrative purposes only.
1-5
How to Adjust the Glide Buttons
1 Using proper lifting techniques, lay the
machine on a table or other suitable work
station.
2 Remove the inner frame stop angle mounting
fasteners. Remove the inner frame stop angle.
3 Slide the inner frame out the bottom of the
outer frame approximately 6 inches / 15.2 cm.
4 Use a soft metal drift to remove the glide
button.
5 Press the new glide button into place until it is
fully seated.
6 Slide the inner frame into the outer frame and
install the inner frame stop angle.