Terex Genie Lift Tools Expo Installer Z-60/34, Дополнение к руководству оператора, Страница: 11 / 17

First Edition • Fourth Printing
Operator's Manual Supplement
Operating Instructions
Part No. 1292178GT 11
Operati ng I nstr ucti ons
Lift Tools™ Access Deck Operation
1 Verify the Access Deck installation instructions
have been followed properly and that the
Access Deck and handle are secured with
locking pins to the platform railings.
Tip-over hazard The weight of
the Access Deck will reduce
the rated platform capacity of
the machine and must be
factored into the platform
load.
Occupants must wear a
safety belt or harness in
accordance with
governmental
regulations. Attach the
lanyard to the anchor
provided in the platform.
Lanyard to be 6 ft
retractable.
Do not sit, stand, or
climb on the platform
guard rails and Access
Deck toeboard. Maintain
a firm footing on the
platform or Access Deck
floor at all times.
2 Pull the lock pin on the right side of the step to
lower and swing Access Deck step down.
3 Rotate the handle up to the vertical position.
Secure the handle with the 3/8" lock pin on the
handle assembly.
Annual Inspection
Inspect for missing or loose components.
Check all fasteners are properly tightened.
Inspect all components for damage or wear.
Check for cracks, bends and corrosion.
Inspect all welds for cracks.
Verify the Access Deck rotates freely about the
right wear-pad slot on the mid-rail.
Verify the locking cam engages the mid-rail with
audible click and locks fully with the pop pin on the
deck.
Verify the pop pin on the step engages in both the
open and closed position with audible click.
Verify the handle can freely rotate around the
shoulder bolt.
Verify the detent pin and lock the handle both up
and down.
Inspection After a Fall
Note: In the event of an operator fall, the Access
Deck and the Genie boom must be immediately
removed from service and inspected by a
"qualified person". If the Access Deck and the
Genie boom pass the inspections listed below, the
Access Deck and the Genie boom may be
returned to service.
Inspect all structural components of the Access
Deck and the Genie boom. Replace any bent or
damaged components. Replace any components
with cracked welds. Replace all mounting
fasteners for the Access Deck.
Perform an Annual Inspection on the Access Deck
Perform a Pre-Operation Inspection on both the
Access Deck and the Genie boom.