13
ã
Terberg Machines B.V. IJsselstein, The Netherlands
All rights reserved. No part of this book may be reproduced, stored in database or retrieval system, or published, in any form or in any way,
electronically, mechanically, by print, photoprint, microfilm or any other means without prior written permission from the publisher.
4.2 Assembly of the bin lift system on the body of the refuse collection vehicle
Tools required:
- Spanners/ring spanners 10, 19 and 24 mm.
- Mobile hoist/crane with minimum lifting capacity 1000 kg.
- Hoist beam with chains.
- Make sure that the refuse collection vehicle on which the bin lift is
being mounted is standing on a level surface.
- Switch off the engine of the refuse collection vehicle and remove the
ignition key from the ignition switch (keep on your person).
- Fit the supports (A) for the bin lift to rest on at the correct height at
the back of the refuse collection vehicle.
- Fit a guide plate between these supports at a minimum angle of 45°; this plate is to guide the tipped waste
into the hopper.
- Make sure that the lifting chairs are in the lowest position before beginning to lift.
- Connect the bin lift to a hoist beam.
- Raise the bin lift to build-on height using a lifting installation with minimum lifting capacity of 1000 kg.
- Position the bin lift on the assembly supports (A).
- Fix the bin lift to the assembly frame on the refuse
collection vehicle using M16 bolts (class 8.8), lock nuts and
washers (DIN 6340) with a tightening torque of 200 Nm.
* Build on height for loaded vehicle,
minimum: 1140mm
maximum: 1200mm
Terberg Machines B.V. recommends: 1200mm.
When mounting the bin lift on the compaction
body standard EN 1501-5 shall be observed.
Ensure that the support is strong enough to
bear the load of the bin lift system plus the
weight of a full bin/container (max. total weight).
420
955
145
7
189
5
0
min. 45°
141
0
153
6
A
A
11
40
- 1
20
0 m
m*
Ø18
BACK OF REFUSE
COLLECTION VEHICLE
DETAIL of support (A)
