Demonstration
14
Demonstration
4
This chapter illustrates how to use the THDB-H2G board to a HSMC-interfaced host board.
1-9
Connecting THDB-H2G Board to a Cyclone III Starter Board
This section describes how to use the THDB-H2G board with a Cyclone III Starter Board.
Figure 4.1 illustrates how the THDB-H2G board is connected to the Cyclone III starter board. Users need to
pay extra attention to the following two points:
1.
Observe the orientation of the HSMC connector when connecting the THDB-H2G to the Cyclone III
Starter Board.
2.
Note that there are two LVDS pairs on the HSMC connector: the HSMC_CLK_p1/n1 (form a close
loop via R3) and HSMC_CLKIN_p2/n2 (form a close loop via R4). Therefore, using any one of the
signal in a LVDS pair under single-ended mode will prevent users from using the other signal in the
same pair.
Figure 4.1 Connecting the THDB-H2G board to the Cyclone III starter board
