DE10-Nano
Getting Started Guide
July 25, 2017
www.terasic.com.tw
13
4.
After the driver is correctly installed, the device will be recognized as Intel USB-Blaster II, as
shown in following picture.
Figure 4-2 USB-Blaster II driver is installed correctly
4.3 Downloading a FPGA SRAM Object File
The Quartus II Programmer is used to configure the FPGA with a specific .sof file. Before
configuring the FPGA, ensure that the Quartus II software and the USB-Blaster II driver are installed
on the host computer.
If users would like to program their SRAM Object File (.sof) into the Cyclone V SOC FPGA device
on the DE10-Nano board, there are two devices (FPGA and HPS) on the JTAG Chain. The configure
flow is different from the one used with DE0-Nano. The section below shows the step-by-step
procedure of programming flow with JTAG mode.
1.
Connect your computer to the DE10-Nano board by plugging the USB cable into the USB
connector (J13) of DE10-Nano and power up the board. (details shown in
Chapter 2
)
2.
Open the Quartus II software and select Tools > Programmer. The Programmer window will
appear.
