Electrical
The electrical voltage required to operate this pump can burn, shock, or even cause
death. Before, installing, operating or servicing this pump, please thoroughly read
through this manual.
DO NOT operate this pump anywhere near explosive or flammable material.
Serious personal injury, death, or major property damage will result.
Accidental starting of the pump can cause severe injury or death.
DO NOT
, splice the power cord.
It is absolutely essential that the rotation of the pump be checked. All the pumps
covered in this manual turn clockwise as viewed from the motor end.
If the motor protector trips frequently, check for the cause. It could be due to impeller
blockage, wrong/low voltage, etc…
For Automatic operation, the pump must stop before the water level reaches Pump
Minimum Water Level.(W.M.L.)
This pump comes with a built in motor protector. In the event of a current overload
or overheating, the pump will stop automatically to protect the motor. After the motor
cools down, the motor protector will automatically reset and the pump can be used
again.
DO NOT
, handle or service the pump while it is connected to the power supply.
ALWAYS
, ensure that the voltage and frequency supplied to the pump are correct.
Refer to the nameplate to determine the correct voltage and frequency.
ALWAYS
, make sure the pump is grounded properly in accordance to local law.
DO NOT
, connect the ground wire to gas pipe, water pipe, etc… as improper
grounding will result in electrical shock.
PUMP OPERATION
DANGER
INSTALLATION
ALWAYS
, place the pump in an upright position. Ensure, that the pump will not burrow
itself on the soft sand or mud.
All piping must be independently supported, properly aligned and capable of handling
semi-solids.
DO NOT
, restrict the discharge flow of the pump as it will cause the pump to overheat.
Be mindful of the discharge hose whipping under pressure.
To avoid backflow or outflow of the pump. Backflow, discharge hose is above the water
surface. Outflow, the discharge hose is above the source water surface.
NEVER
, allow the pump to freeze in the liquid it is pumping.
The Guide Rail System, is to be installed on a hard level surface such as cement,
asphalt, etc… Do not, place the pump directly on soft sand or mud.
Pump Mount
Piping
NOTICE
NOTICE
