© 2 0 1 4 . T e r a d e k , L L C
P a g e |
1 0
Streamer
Mode – Select
P2P
mode when streaming to a client via WiFi or to a single receiver on a LAN. Select
Multicast
when
streaming to 2-4 Beam receivers wirelessly or to many devices over a multicast-enabled wired network.
Encapsulation – Select
RTP
when streaming to a Beam RX or when the RTSP server is enabled. Select
UDP TS
when
using MPEG-TS to a compatible decoder.
RTSP Server – Enabling this allows multiple clients to pull the stream from an encoder using the RTSP stream mode.
Audio
Mode – Select
Stereo
,
Mono
, or
Disabled
for the primary embedded audio stream.
IFB – Select
Enabled
to allow for two-way stereo talkback communication.
Factory Default – To reset all settings to their factory default values, select this menu, and then select Reset All Settings. The
device reboots after the configuration is reset.
Beam RX
Decoder – Use this menu to set the decoder ID value. When streaming from one Beam TX to multiple Beam RX units, each RX
must be configured with a different ID. There are four different IDs available.
WiFi – This menu allows you to configure the WiFi SSID and channel, or to enable Ethernet LAN mode. See the encoder WiFi
menu description for the available options.
Streamer
Mode – Select
P2P
mode when streaming point-to-point over WiFi or a LAN. Select
Multicast
when connecting to a
multicast encoder. If multicast is selected, the
Group IP
can be configured via the web UI.
Relay Server – Enable this to allow the Beam decoder to re-stream the video it receives from an encoder. The encoder
determines whether the relay server uses RTSP or MPEG-TS.
o
RTSP: stream available at
rtsp://192.168.0.162:8554/stream
when streaming over Ethernet, or
rtsp://192.168.2.2:8554/stream if streaming over WiFi. Note that the URL will change if the Ethernet address is
changed.
o
MPEG-TS: If the encoder encapsulation is UDP TS, the decoder will output a transport stream. Configure the stream
destination and port via the web UI.
Audio
IFB – Select
Enabled
to allow for two-way stereo talkback communication.
Factory Default – To reset all settings to their factory default values, select this menu, and then select Reset All Settings. The
device reboots after the configuration is reset.
