ENC-400-HDMI
™ H.264 Encoder
User Guide V 2.1
37
3.4.11 Menu: Network / Settings
shows the ‘Network / Settings’ page of the ENC-300™ encoder. Set the encoder's own IP-
address, subnet mask, gateway address and define the encoder's host name.
Figure 22: Network/Settings page of the ENC-
300™ encoder
describes the ‘Network / Settings’ page of the ENC-300™.
Settings:
Description:
Link Mode:
Specifies the network port characteristics of the ENC-
300™. This option has been
added especially to address specialized network and/or administration
requirements.
.!.
In most cases it is sufficient (and recommended) to leave
this
setting on ‘AUTO’, so the ENC-300™ and
the connected switch can deal
out the preferred
connection on their own.
DHCP:
Enables / Disables DHCP. (Read-Only)
Host Name:
Specifies the hostname of the ENC-
300™ blade. Please enter your desired
hostname of the ENC-
300™ blade. The hostname will be also display at the tabs
of your web browser.
IP Address:
Specifies the IP-address of the ENC-
300™. The IP-address is an identifier for your
ENC in the TCP/IP network. Networks use the TCP/IP protocol route messages
based on the IP-address of the destination. The format of an IP-address is a 32-
bit numeric address written as four numbers separated by periods. Each number
can range from 0 to 255. E.g.: 172.16.20.100
Subnet Mask:
Specifies the subnet mask of the ENC-
300™. A subnet mask is a 32-bitmask used
to divide an IP-address into subnet and specify the networks available hosts. E.g.:
255.255.0.0 is the net mask for a class-B IP-address like 172.16.20.100.
Broadcast
Address:
Shows the framerate in fps of the received stream. (Read only)
Gateway
Address:
Defines IP-address of your gateway. The gateway is commonly the address of the
network device such as a network router.
DNS Server
IP address of the DNS (Domain Name Server)
DNS Domain
Domain name
Table 16: Description of the NETWORK/SETTINGS webpage of the ENC-
300™
.!.
When the IP-address has been changed, the encoder needs to be reset (reboot), in
order for the new IP-address to take effect. When changing the IP-address please type
in the new IP-address, subnet mask, gateway-address and host name. Then hit the
‘SAVE’ button and then the ‘REBOOT’ button.
.!.
When DHCP is enabled you could use the Teracue Product Finder to find your ENC-
300™