Marquee™ Point-to-Point Series User Guide
3. Turn the pivot adaptor bracket (B) so that the rectangular part is parallel with the surface of the
Marquee FP. Fasten the Marquee unit to the pole using pole clamp (C), U-bolt (D), and two nuts, as
shown in Fig 2.5. Tighten hardware (two places). The pole clamp (C) and U-bolt (D) will accept pole
diameters between 0.75” to 1.5” OD.
Figure 2.5 – Attaching the Marquee FP Unit to the Pole
(D)
(B)
(C)
Min 0.75”
Max 1.5”
(A)
Proceed to Section 2.7 – Cabling the Marquee (All Enclosures).
2.6
Hardware Installation – EX Enclosure
NOTE:
All connectors must be properly water-proofed with all-weather electrical tape, Permagum, or
equivalent.
Do not use Silicon glue
.
The Marquee EX unit is installed by using an “X”-shaped adaptor bracket (A) that is secured to the pole
with a pole mounting bracket (B), and a pole clamp (C). Figure 2.6 shows the hardware provided to mount
the Marquee EX unit.
Figure 2.6 – Marquee EX Mounting Hardware
Hardware
Qty
Screw Hex Head M5x20
4
(for Gigalink 5x45 only)
Screw Hex Head M8x40
4
(for poles between 1” to 1.75” OD)
Screw Hex Head M8x70
2
(for poles between 1.75” to 3” OD)
Lock Washer M5
4
Flat Washer M5
4
Nut M5
4
Lock Washer M8
4
Flat Washer M8
6
Nut M8
2
Arm (For indoor
installations only,
not used)
“X”-Shaped Adaptor
Bracket (A)
Pole Clamp (C)
Pole Mounting
Bracket (B)
Version 1.2
Page 6
February 2005
