6
t
Step 4
Step 3
5
3. Connect Gas hose & Regulator (3) to Pizza Oven (2).
4. Assemble the pizza shovel.
WARNING
• Please always keep the gas bottle in upright position.
• If the appliance is not in use, the gas must be turned off at the supply cylinder.
• The minimum distance for the appliance and the 20lb gas tank is 40 inches apart.
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1. The cylinder valve should be in OFF position.
2. Make sure the burner valve is in OFF position.
3. Inspect the valve connections, port and regulator assembly. Remove debris and inspect the hose for damage.
4. When connecting the regulator assembly to the valve, use your hand to tighten the nut clockwise until it tops.
5. Use of a wrench could damage the quick coupling nut and result in a hazardous situation.
6. Open the cylinder valve fully by turning the valve counterclockwise.
7. Before lighting the oven, use a soap and water solution to check all connections for leaks.
8. If a leak is found, turn the cylinder valve OFF, and do not use the oven until local liquid propane dealer make repairs.
CLOSE THE LIQUID PROPANE GAS CYLINDER
1.Turn the oven burner valve OFF and make sure the oven is cool.
2. Turn the liquid propane cylinder valve OFF by turning clockwise until it stops.
3. Detach the regulator assembly from the cylinder valve by turning the quick coupling nut counterclockwise.
4. Place dust cap for cylinder valve outlet whenever the cylinder is not in use.
LEAK TESTING
GENERAL
Although the gas connections of the appliance are leak tested prior packing and shipment, a complete test must be performed at the installation site
and before each use.Check all the gas connections for leak testing using the procedure listed below. If the smell of gas is detected at any time, you
should immediately stop using and check the entire system for leaks.
BEFORE TESTING
Make sure all packing material has been removed from the appliance.
Make a solution of one part liquid detergent and one part water. You will need a spray bottle, brush or rag to apply the solution to the fittings.
A
B
C
D
Connect the gas hose and the regulator (3) to the pizza oven (2).
5
3. Connect Gas hose & Regulator (3) to Pizza Oven (2).
4. Assemble the pizza shovel.
WARNING
• Please always keep the gas bottle in upright position.
• If the appliance is not in use, the gas must be turned off at the supply cylinder.
• The minimum distance for the appliance and the 20lb gas tank is 40 inches apart.
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1. The cylinder valve should be in OFF position.
2. Make sure the burner valve is in OFF position.
3. Inspect the valve connections, port and regulator assembly. Remove debris and inspect the hose for damage.
4. When connecting the regulator assembly to the valve, use your hand to tighten the nut clockwise until it tops.
5. Use of a wrench could damage the quick coupling nut and result in a hazardous situation.
6. Open the cylinder valve fully by turning the valve counterclockwise.
7. Before lighting the oven, use a soap and water solution to check all connections for leaks.
8. If a leak is found, turn the cylinder valve OFF, and do not use the oven until local liquid propane dealer make repairs.
CLOSE THE LIQUID PROPANE GAS CYLINDER
1.Turn the oven burner valve OFF and make sure the oven is cool.
2. Turn the liquid propane cylinder valve OFF by turning clockwise until it stops.
3. Detach the regulator assembly from the cylinder valve by turning the quick coupling nut counterclockwise.
4. Place dust cap for cylinder valve outlet whenever the cylinder is not in use.
LEAK TESTING
GENERAL
Although the gas connections of the appliance are leak tested prior packing and shipment, a complete test must be performed at the installation site
and before each use.Check all the gas connections for leak testing using the procedure listed below. If the smell of gas is detected at any time, you
should immediately stop using and check the entire system for leaks.
BEFORE TESTING
Make sure all packing material has been removed from the appliance.
Make a solution of one part liquid detergent and one part water. You will need a spray bottle, brush or rag to apply the solution to the fittings.
A
B
C
D
Assemble the pizza peel.
Connecting the Gas Bottle
This pizza oven is suited only for low-pressure butane/propane
gas and must be equipped with a suitable low-pressure regula-
tor and a flexible hose. The gas hose must be connected with
suitable hose clamps. This pizza oven is intended to operate
a 50 mBar regulator with butane/propane gas. Use a suitable
regulator that is certified according to BSEN 12864:2001. In-
quire about suitable regulators for gas bottles at your LPG gas
supplier. For the operation of this pizza oven, you require a com-
mercially available 5 kg bottle of propane/butane gas.
Please note: The gas bottle and gas hose have a left-hand
thread!
Regulator and Hose
These accessory parts are supplied with the gas pizza oven.
Replacements are available at your pizza oven distributor or an
authorised LPG gas supplier. Use only regulators and hoses
that are certified for LP gas with the pressure values mentioned.
The lifespan of the regulator is approximately 2 years. It is rec-
ommended that the regulator be exchanged within 2 years from
the production date.
The use of an incorrect or defective regulator and gas hose is
dangerous. Before each use of the gas pizza oven, check that
the correct parts are being used.
The gas hose used must conform to the regulations and pro-
visions of the country in which the pizza oven is being used.
The length of the gas hose must not exceed 1.5 metres. Worn
or damaged hoses must be exchanged immediately.
The hose
must be connected without twists or bends.
Ensure that the
gas hose is not bent or constricted and that it does not come into
contact with the gas pizza oven, with the exception of the hose
connection.
Storing the pizza oven
The gas pizza oven must only be stored indoors, once the gas
bottle has been removed. If the pizza oven is not being used for
an extended period of time, it should be covered with a protec-
tive hood and stored in a dry and dust-free environment.
P21097_TEPRO_3317_GasPizzaofen_Burnsville_DE_GB_210901.indd 15
1/9/2021 2:56 PM
