23´-9˝
9´-3˝
40´
40´
20´
20´
• Release handle, crank until slot is
pointing up
• Close handle
• Pass strap underneath and through
the slot (as shown)
• While holding the whole strap
assembly attach both ends
(eg. tent to stake)
• Remove slack, before tightening
• Push ‘release’— lift handle
and tighten ratchet
• Roll-up any excess strap,
put under handle
• Close handle
FINISHED TENT
1˝Ratchet strap assembly
(one per leg location)
1.5˝Ratchet strap assembly
and base plate
(one per leg location)
7
1.) Remove base stakes
2.) Detach short straps under canopy
3.) Remove straps on one side
4.) Remove leg poles, on one side
5.) Remove side leg poles,
(adjacent to corner of 30 x 30 tent, only)
6.) Remove center mast
7.) Lay tarp under canopy
8.) Remove remaining straps
9.) Remove remaining legs
10.) Fold canopy
11.) Disconnect/remove eave poles
and connectors
12.) Remove ground stakes
STRIKE PROCEDURE
(basically, reverse order from assembly)
USING RATCHET STRAPS
Release
(push, to lift handle
and to remove strap,
during disassembly)
Handle
Axle/Slot
716 832-TENT
(
8368
)
canopy
overhang
14˝
7˝
Optional Rain Gutter Available
– HPF Rain Gutter (attached view)
(Note: the vinyl is connected to both tents,
forming a ‘V’ shaped gutter)
SKUs: BT-FH10RG (10´), BT-FH15RG (15´), BT-FH20RG (20´),
BT-FH30RG (30´), BT-FH40RG (40´)
