TENSPros
13
12
3. On/Off Switch and Intensity Controls:
If both controllers are in the off-position (white markings on the
housing), the device is switched off.
By turning the controls clockwise, the appropriate channel is
switched on and the impulse display led will illuminate and begin
to pulse according to the frequency set.
The current strength of the impulses transmitted to the electrodes
in creases the further the controller is turned clockwise.
To reduce the current strength an/or switch the device off, turn
the controller counter clockwise or turn counter clockwise until it
stops, respectively.
4. Lead Connector
Connection of the electrodes is made with two-lead connector.
The device must be switched off before connecting the cables.
Both intensity controls must be at the Off position. Electrodes
must be pressed firmly on the skin.
Important
1. Do not apply to broken skin.
2. The electrodes should be discarded when they are no longer
adhering.
3. The electrodes are intended for single patient use only.
4. If irritation occurs, discontinue use and consult your physician.
5. Read the instruction for use of self-adhesive electrodes before
application.
Chapter 18 : ADJUSTING THE CONTROLS
1. Panel Cover:
A slide-on panel cover covers the controls for Contraction Time,
Relaxation Time, Ramp Time, Pulse Width, and Pulse Rate. Your
medical profes sional may wish to set these controllers for you
and request that you leave the cover in place.
2. Display Led
Each of these leds illuminates whenever
the electronics of the device create a
current impulse at contraction time and
does not illuminate when the stimulation
is ceased at relaxation time. Due to the
capacity of the human eye, the
illumination of the lamp can only be
recognized up to a frequency of
approximately 30 Hz. At higher
frequencies, the lamp will appear to be
constantly illuminated.
PDF created with FinePrint pdfFactory trial version
