Tenor phono1, Руководство пользователя

Страница: 30 / 35

Care and Maintenance
Wood Faceplate and Top Rails
The hand lacquered Wood Faceplate and Top Rails of the Phono 1 require very little
maintenance. Should they become marked with fingerprints, a polish used for fine fur-
niture can be used but only if applied to a soft cloth and then rubbed on the wood.
Spraying polish directly on the wood may contaminate the electrical components inside
and could void the Warranty. Keep out of direct sunlight if at all possible as the cherry
wood will darken substantially.
Metal Chassis and Top Plate
The Metal Chassis and Top Plate need very little care other than dusting from time to
time. Do not use spray wax or dusting liquid as it may contaminate the electrical com-
ponents inside and could void your Warranty. Dusting with a soft brush is recommended.
Electrical Connections on Rear Plate
From time to time it is good to disconnect and reconnect your cables at the rear to im-
prove any degradation due to normal electrical oxidization. Make sure your amplifier is
turned off when you do this and that you disconnect then reconnect each connecter one
at a time to avoid any mix up.
Audio Board (Vacuum Tubes)
The Audio Board is home to all of the Vacuum Tubes in the Tenor Phono 1. Every tube is
matched and calibrated in the circuit so unless you are specifically directed by Tenor to
alter these tubes they should never be touched except by trained Tenor service techni-
cians. Each tube has been selected for its optimum electrical characteristics and the
entire circuit has been calibrated for these specific tubes. Any alteration of the tubes
may cause the Tenor Phono 1 to be out of specification and any failure as a result would
not be covered by Warranty.
Page of 27 32