ASSEMBLY OF VERTICAL SHELVING UNIT
Two people are recommended for assembly. Approximate assembly time: 15-20 minutes.
The reference numbers used throughout this sheet refer to the illustration on the back cover.
This is to help you to identify the various parts as they are mentioned.
1.
Create a unit end by connecting two uprights
(Ref. No. 1) with one of the front-to-back shelf
supports (Ref. No. 2) by inserting the shelf support
rivets into the bottom two keyhole slots of each
upright using a rubber mallet to seat the upright
securely in the keyhole slots.
NOTE: Be sure that the narrow end of
the keyhole slots are pointing downward,
and the flat edge of the shelf support
is facing up.
Tool Required: Rubber Mallet
2.
Place a second front-to-back shelf support halfway up the upright
assembly to complete one bottom side. Repeat
these steps to prepare a second set of uprights
giving you two upright end assemblies. Set them
with the angled
corners facing
inward toward
each other.
3.
Connect two of the left-to-right shelf supports
(Ref. No. 3) between the two assemblies, one
on each side with angled corners facing
toward each other. Be sure to use
the two keyhole slots
nearest the floor, as
in step 1.
NOTE: As in step one,
make sure the flat
edge of the shelf
supports are facing
upwards. If this has
been done correctly,
there would now be
a flat surface around
all four edges on which to lay the bottom particle board
shelf. If any edges have an upward facing angled edge, the
support has been inserted upside down.
4.
Repeat step 3 halfway up the upright post.
5.
Mount another upright
post to the top of one of
the other uprights and
attach with a shelf
support as in step 1,
mounting the bottom
rivet of the shelf support
in the bottom upright
post and the top rivet
in the new upright post as
shown below.
6.
Place another upright
post on the opposite side
of the one you just
mounted. Using the
other side of the same
shelf support, attach in
the same way described
in step 5.
NOTE: Be sure that the narrow
end of the keyhole slots of the
new posts are pointing down
ward, and that the flat side of
the shelf support is facing
upward.
