ASSEMBLY OF J1878A-N-W CABINET
Tools Needed:
A free
11
/
32
” nut driver is included with each Tennsco cabinet.
Two people are recommended for assembly. Approximate assembly time: 30-40 minutes.
2.
Place the 2-piece cabinet back (Ref.
No. 1) on a protected surface to
prevent scratching the paint.
The flange on the
bottom of the back
should be facing upward.
Bolt the back panels together with
seven bolts and nuts (Ref Nos. 19 & 20).
1.
The reference numbers used throughout this sheet refer
to the illustration on the back cover. This is to help you
to identify the various parts as they are mentioned.
3.
Attach the left side (Ref. No. 2) to the back by placing
flange (A) around the back and bolting together with
seven bolts and nuts. Be sure that the lances on all
shelf adjustment strips (B) point in the same direction.
5.
Attach the right side (Ref. No. 3) to the back in the same manner
as you did in step 3, again, making sure that the flange is
around the back and that the lances on the shelf adjustment
strips are pointed in the same direction as those on the back and
left side. Push the side panel up so the studs in the top go
through the holes in the top
flange of the side and
fasten with three
nuts as in
step 4).
6.
Attach the sill (Ref. No. 8) to the sides. Place nuts loosely on each
of the studs and slide the ends of the sill into the slots on both
sides of the unit. Then, securely tighten the nuts.
4.
Attach the top (Ref. No. 5) to the unit by sliding the outer
flange over the back of the unit and the side flange on
the top over the side panel. The
threaded studs should go
through the holes in the
top flange of the
side and
fasten with
three nuts.
Attach the
back to the
top using four
bolts and nuts.
7.
Place the rear flange of one of the shelves (Ref. No. 4) into the
four bottom lances of the back. The front of the shelf will rest
on the sill.
All lances point UP on
both backs and side
.
Flange goes
under back.
Flange faces upward.
Flanges
face upward
Threaded studs go
through the holes
in the flange at the
top of the side.
Slide ends in to the slots
on the bottom of the sides.
Nuts placed loosely
on studs of the sill.
Insert bottom into
bottom lances
.
B
A
NOTE: When bolting the unit together, leave
the bolts slightly loose until Step 10, unless
otherwise specified.