1.
Place the locking handle
(Ref. No. 10) on the right
hand door and fasten with
two #8-32 X
1
/
4
hex-head
bolts and lock washers,
provided with the handle.
2.
Turn the handle to the
open position and
place the locking cam
(Ref. No. 11) over the
square shank of the
door handle. The latch
must be facing downward
as shown. Then place the
locking cotter pin (Ref. No.
13) through the hole of the
square shank.
3.
With the handle still in the open position, hook the
locking bars (Ref. No. 9) to the locking cam (see
“A” at left). Once in position, slowly rotate the door
handle to the closed position so the lock bars
prot rude from the holes at the top and bottom
of the door (shown at right, below).
4.
Slide the nylon lock bar
guide inserts (Ref. No.
12) over the lock bar
ends and through the
door slots (see “B” at
right). Push down firmly
until the guides snap
into place.
5.
Attach the “dummy” handle
(Ref. No. 14) using two
#8-32 X
1
/
4
hex-head bolts
and lock washers.
Handle/Locking System Installation
A
B
B
8.
Set the unit upright. Insert the second shelf at the desired
level. Be sure that the flange with the two holes should
face the front.
10.
Cabinet must be level for doors to
open and close properly. Insert a
flathead screwdriver into the two
leveling holes and turn the screws
until the cabinet is level. The cabinet
is now ready for use.
NOTE: In order to place the shelf, you must first tilt
the shelf slightly to the left or right before inserting
into the unit.
9.
Attach the left door (Ref. No. 6) to the unit by placing the
door on the hinges, aligning the hinge holes, placing the
hinge pins (Ref. No. 15) into the slots and tapping them in
until secure. Attach the right door (Ref. No. 7) to the unit
in the same manner as the left door.