ASSEMBLY OF A CAPSTONE SHELVING UNIT
Two people are recommended for assembly. Approximate assembly time: 20-30 minutes.
2.
Place one shelf support (Ref. No. 5) in the top keyhole slots
of the uprights (Ref. No. 1). Place a bottom shelf support at
the back section, in the bottom keyhole slots on the uprights
as well for stability. Position the front base (Ref. No. 6) inside the
upright posts, with the flange on the floor before inserting the
next shelf support in the front bottom. Place the four plastic feet
(Ref. Nos. 7) on the bottom of the uprights to aid
1.
The reference numbers used throughout this sheet refer to
the illustration on the back cover. This is to help you to
identify the various parts as they are mentioned.
3.
Place the shelf reinforcement (Ref. No. 4) on the shelf
supports making sure that the gooves in the reinforcement
are connected securely to the edges of the supports. For best
support, divide the space between the reinforcements and
the uprights into equal spaces.
4.
Shelves (Ref. No. 2) should be tilted in as shown below. The
square hole on the side flange of the shelf goes to the rear
of the unit. The round hole on the side flange goes toward
the front of the unit.
NOTE: If joining units together, use a “T” post adder upright
instead of an “L” post starter upright.
NOTE: Make sure that all the shelf
supports are seated properly.
NOTE: The narrow part of the
keyhole slot on the uprights
should be toward the floor,
while the wide part should
be toward the top.
UP
DOWN
NOTE: Unit includes plastic fee to prevent posts from damaging
the floor. If you are assembling an Adder unit, you will recieve
the LTNF-T instead of the LTNF-L as show above.
