NOTE: The above diagram shows all the
accessories available.
6.
Attach the accessories (Ref. No.’s 5 - 11). Angle the piece
so the back of the hooks are just above the holes on the
upright frames. Slide the hooks into the holes and push
down. Ensure both sides of each accessory is on the same
level of holes on each upright.
5.
Attach the divider shelf to the cantilever upright frames.
(See step 6 on how to attach). Using the help of an
associate, place the upright frames with the divider
shelf attached to the packing table. Use this as
a template to mark the locations for the holes in the
top. Remove the cantilever system off the top and
unhook the divider shelf from the uprights.
For steel tops
, drill four
5
/
16
” holes into the top. Then
attach the uprights to the top using
1
/
4
”-20 x
5
/
8
” bolts and
nuts, with a flat washer under the top for security.
For wood tops, drill
5
/
32
” pilot holes
3
/
4
” deep. Use #14 x 3/4”
hex head slotted wood screws to attach each upright to the
top.
