8.
Place a shelf reinforcement (Ref. No. 8) across the two shelf supports.
The slot in each end of the shelf reinforcement should fit over the
ridge of the shelf support.
9.
Attach one center stop (Ref. No. 4) to one of the slotted shelves (Ref.
No. 5) by aligning the three holes in the center stop
flange with the holes in the center of
the shelf. Attach with three
10-24 x 1/2” bolts
and nuts
(Ref. Nos. 9 & 10).
13.
Insert shelf dividers (Ref. No. 7) by placing dividers into slots on
shelf and then hooking into the slot in the back stop. You have
been provided with enough dividers for ten per shelf level (five
on each side of the shelf), but these can be placed in whatever
position most suits your needs.
14.
If you are assembling only a single unit, assembly is now complete
(shown below left). If you are assembling multiple units joined
together, your starter unit should have been assembled with a “T”
upright (shown below right), as described in step 1. Continue with
step 15.
15.
Repeat steps 4 through 13, adding the shelf supports to the “T”
upright already in place on the unit.
NOTE: The plain shelf
(without slots) is for the
unit top.
10.
Place the shelf, with the
center stop attached,
onto the unit by lowering it
over the top of the shelf
supports. The edges
of the shelf should fit over
the top of the shelf
supports, hiding them
from view.
11.
Continue the assembly
by placing supports, shelves,
reinforcements and center
stops as described in steps
7 through 10. The
recommended spacing
between shelves is twelve
inches, which equals six open
keyhole slots between
supports. If necessary, move
the temporarily places
reinforcement from step 6.
12.
The top shelf supports and top shelf (Ref. No. 6) should be installed
flush with the upright top. Note that the top shelf has no divider slots.
No shelf reinforcements are needed under top shelf.
Completed Single Unit
Completed Unit Ready for Add-on
NOTE: 48” wide
units will use two
shelf reinforcements
per shelf level,
equally spaced.