Tennsco 1470RH Скачать руководство пользователя страница 2

ASSEMBLY OF 1470RH OR 1480RH CABINET

Tools Needed:

 A free 

11

/

32

” nut driver is included with each Tennsco cabinet.  

Two people are recommended for assembly. Approximate assembly time: 30-40 minutes.

2.

 

Place the cabinet back (Ref. No. 1) on a   

 

protected surface to prevent  

 

scratching the paint. 

 

The flange on the 

 

bottom of the back 

 

should be facing upward.

1.

 

The reference numbers used throughout this sheet refer 

 

to the illustration on the back cover. This is to help you 

 

to identify the various parts as they are mentioned.

3.

 

Attach the left side (Ref. No. 2) to the back by placing 

 

flange (A) around the back and bolting together with 

 

seven bolts and nuts (Ref. Nos. 17 & 18). Be sure that the   

 

lances on all shelf adjustment strips (B) are pointing in the  

 

same direction.

5.

 

Attach the right side (Ref. No. 3) to the back in the same manner 

 

as you did in step 3, again, making sure that the flange is   

 

around the back and that the lances on the shelf adjustment  

 

strips are pointed in the same direction as those on the back and  

 

left side. Push the side panel up so the studs in the top go  

 

through the holes in the top 

 

flange of the side and 

 

fasten with three 

 

nuts as in 

 

step 4).

6.

 

Attach the sill (Ref. No. 6) to the sides. Place nuts loosely on each  

 

of the studs and slide the ends of the sill into the slots on both  

 

sides of the unit. Then, securely tighten the nuts.

4.

 

Attach the top (Ref. No. 5) to the unit by sliding the outer  

 

flange over the back of the unit and the side flange on  

 

the top over the side panel. The threaded studs should go 

 

through the holes in the top  

 

flange of the 

 

side and 

 

fasten with 

 

three nuts. 

 

Attach the 

 

back to the 

 

top using four 

 

bolts and nuts.

7.

 

Place the rear flange of the bottom (Ref. No. 7) into the    

 

bottom lances of the back. The flange with two holes should  

 

face the front, hanging over the sill. Insert the bolts through  

 

the bottom and still with the head 

 

facing the front of the unit. 

 

Secure with  

 

two nuts.

All lances point UP on 

both backs and side

.

Flange goes

under back.

Flange faces upward.

Flanges 

face upward

Threaded studs go 
through the holes 
in the flange at the 
top of the side.

Slide ends in to the slots 
on the bottom of the sides.

Nuts placed loosely
on studs of the sill.

Insert bottom into 

bottom lances

.

B

A

 

NOTE: When bolting the unit together, leave  

 

the bolts slightly loose until Step 8, unless  

 

otherwise specified.

 

NOTE: All illustrations show a solid door. Assembly  

 

for C-Thru doors (CVD1470/CVD1480) is identical.

Two holes must 

be in fr

ont

Отзывы: