IB 340831 (01- 2016)
2
INSTALLATION:
FIG. 1
1. Drill four 6.50 mm (0.256 in.) holes into the
top of the recovery tank cover. (Fig. 1)
2. Drill two 3.17 mm (0.125 in.) holes into the top
of the recovery tank cover. (Fig. 1)
3. Use four plastic rivets (2) to install the bag (1)
onto the recovery tank cover. (Fig. 3)
4. Use a hex screw (11) and three flat washers
(10) to install each finger grip clip (9) onto the
recovery tank cover. (Fig. 3)
5. Install the squeegee shoe (7) onto the wand
nozzle (8). (Fig. 3)
6. Slide the hose clamp (6) onto the hose (4),
insert the straight fitting (5) into the hose, and
tighten the hose clamp to secure the straight
fitting to the hose. (Fig. 3)
7. Insert the hose (4), wand nozzle (8), and
vacuum wand tubes (3) into the bag (1) and
secure the ends of the vacuum wand tubes
sticking out of the bag into the finger grip clips
(9). (Fig. 2 / Fig. 3)
FIG. 2
8. Use the vacuum wand assembly to clean.
Refer to the Operation Manual for instructions
how to assemble and use the vacuum wand.
