background image

IB 340753 (01- 2007)

1

No. 340753
Machine: T7/SSR
Published: 01- 2007
Rev. 00

INSTRUCTION BULLETIN

NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the

Parts List in the appropriate place in the machine manual for future

reference. Retaining the Parts List will make it easier to reorder

individual parts and will save the cost of ordering an entire kit.

Installation instructions for

kit number 9000136

SYNOPSIS:

This kit contains the parts needed to install the 650mm disk head assembly on T7/SSR machines.

Please follow step-by-step instructions.

SPECIAL TOOLS / CONSIDERATIONS: NONE

(Estimated time to complete: 1 hour)

PROTECT THE ENVIRONMENT

Please dispose of packaging materials, old machine components,

and hazardous fluids in an environmentally safe manner according

to local waste disposal regulations.
Always remember to recycle.

PREPARATION:

1. Empty the solution and recovery tanks. Refer

to the Operators Manual for instructions.

2. Park the machine on a clean level surface and

if necessary raise the scrub head. Turn off the

machine.

3. Remove the brushes from the machine.

4. Turn on the machine and lower the scrub

head and squeegees.

5. Turn off the machine and remove the key.

FOR SAFETY: Before leaving or servicing

machine, stop on level surface, turn off the

machine, and remove the key.

6. Disconnect the battery cables from the

batteries.

WARNING: Always disconnect battery

cables from machine before working on

electrical components.

7. Jack or lift the front end of the machine

between 6” and 12” from the floor, slide the

jack stands underneath the machine, and

lower the machine onto the jack stands. Refer

to the Operators Manual for instructions.

FOR SAFETY: When servicing machine, block

machine tires before jacking up machine. Use

a hoist or jack capable of supporting the

weight of the machine. Jack machine at

designated locations only. Support machine

with jack stands.

Содержание 9000136

Страница 1: ...cycle PREPARATION 1 Empty the solution and recovery tanks Refer to the Operators Manual for instructions 2 Park the machine on a clean level surface and if necessary raise the scrub head Turn off the machine 3 Remove the brushes from the machine 4 Turn on the machine and lower the scrub head and squeegees 5 Turn off the machine and remove the key FOR SAFETY Before leaving or servicing machine stop...

Страница 2: ... Disconnect wires and hose from solenoid valve FIG 1 9 Remove the hardware A holding the scrub head to the machine and slide the scrub head from under the machine Set the hardware aside Refer to Fig 2 10 Remove the lift arms B from the scrub head Set the lift arms and hardware C aside Refer to Fig 2 Remove hardware A not shown from this side of machine also B A A A A A C C C C Actuator FIG 2 ...

Страница 3: ...scrub head lift spring E from the scrub head Set center arm plates scrub head lift spring and all hardware F aside Refer to Fig 3 12 Remove the lift bracket G from the scrub head Set the lift bracket and hardware H aside Refer to Fig 3 D E D F F F F F H G F FIG 3 ...

Страница 4: ...3 4 Position the scrub head under the machine and use the saved hardware A to install the scrub head onto the machine Refer to Fig 2 5 Connect all loose hoses wires and cables disconnected from the removed scrub head to the new scrub head Refer to Fig 1 6 Install the brushes onto the scrub head 7 Remove the jack stands from under the machine and lower the machine to the floor 8 Reconnect the batte...

Отзывы: