Tennant 810 LPG, Руководство оператора

Страница: 65 / 94

MAINTENANCE
63
810 MM309 (11–95)
No. of
Lubricant/ Service
Interval Key Description Procedure Fluid Points
100 Hours 8 Hydraulic fluid reservoir Check fluid level HYDO 1
10 Hydraulic fluid cooler Clean cooler fins – 1
9 Radiator Clean core exterior – 1
Check coolant level WG 1
Clean screen – 1
Tires Check pressure – 3
15 Main brush and hopper Check for damage or wear – 12
seals
12 Engine crankcase Change oil and filter element EO 1
12 Engine Check fan belt tension – 1
200 Hours 12 Engine Steam clean exterior – 1
9 Radiator hoses and clamps Check for tightness and wear – 2
14 Rear wheel support Lubricate SPL 1
bearings
7 Parking brake Check adjustment – 1
3 Side brush pivot pins Lubricate SPL 1
400 Hours 12 Engine Clean or replace and adjust – 4
spark plugs
Replace PCV valve
– 1
Check distributor (for machines
below serial number 2300)
– 1
Replace fuel filters, gasoline – 2
9 Cooling system Flush WG 1
5 Brake master cylinder Check fluid level BF 1
800 Hours 12 Engine Clean PCV hoses, tubes, – 1
and fittings
Torque intake manifold bolts
– 8
Check timing belt – 1
8 Hydraulic reservoir Replace filler cap – 1
Replace suction strainer – 1
Change hydraulic fluid HYDO 1
11 Hydraulic fluid filter Change filter element – 1
Hydraulic hoses Check for wear and damage – 49
14 Propelling motor Torque shaft nut – 1
14 Rear wheel Torque wheel nuts – 1
13 Battery Clean and tighten battery cable – 1
connections
1600 Hours 16 Front wheel bearings Check, lubricate, and adjust SPL 2
12 Engine Replace timing belt – 1
LUBRICANT/FLUID
BF Brake fluid . . . .
EO Engine oil, 10W30 SAE–SG/SH rated . . . .
HYDO Tennant Company or approved hydraulic fluid .
SPL Special lubricant, Lubriplate EMB grease (TENNANT part no. 01433–1) . . .
WG Water and permanent-type ethylene glycol anti-freeze, –34 C (–30 F) . . .
NOTE: Also check procedures indicted ( ) after the first 50-hours of operation.