Tennant 614213-Nobles Scout 24, Руководство оператора и каталог запасных частей

Страница: 10 / 16

8
CONTROL PANEL DISPLAY CODES:
Safety code Cause Actions to take
C22 Short circuit brush protection: Reset by turning OFF the
stops all functions machine and starting again
C14 Dissipater at high The machine resets when
temperature. Activates if temperature lowers under 176° F
temperature is over 194° F
FS0 Worn brushes Replace brush
Yellow led lit Battery in reserve Machine continues to work.
Only a warning that the battery
is near discharge
Red led flashes Battery discharged Machine stops all functions
Turn off machine and charge
the battery
P1.X Sweeping mode 1 button See programming
programming activated
P2.X Sweeping mode 2 button See programming
programming activated
SF.X Filter shaker program See programming
setting activated
X = A VALUE FROM “0” TO “9”
PROGRAMMING:
Your machine is factory programmed for optimum performance. It does not require further programming. However, if
you encounter one of the following codes; P1.x, P2.x or SF.x (x= a value from 0 to 9), use the following programming
instructions to reset your display. Operating the machine in a setting other than the factory setting may cause machine
failure. Machine damage due to improper programming will void your warranty.
PROGRAMMING INSTRUCTIONS:
If your display reads P1.0 , P2.1 or SF.3 simply turn the main power off and back on again to reset display (these are
the factory programmed settings). If your display reads a value greater than stated above (ex. P1.”5” , P2.”7” , SF.”9”)
continue to follow the instructions as described below.
To reprogram the machine to the factory settings, turn the main power ON and press and hold the display switch
button (battery/time symbols) down for at least 3 seconds. P1.x will appear on the display. The P1 value should read
“0” (ex. P1.0). If the value is greater than “0”, press the vacuum fan button until the display reads P1.0. Press the
display switch button again to advance to the next code. The P2.x value should read “1” (ex. P2.1). Press the vacuum
fan button to properly set. Press the display switch one more time to advance to the last code. This code should read
SF.3. If the value is not “3”, press the filter shaker button until the display reads SF.3. To exist the programming mode,
turn machine off.