4
Function buttons
•
The buttons activate features that augment the function selected with the range
selector.
•
Press the button once to access the main feature (e.g. STORE).
•
To access the first additional feature of the button (e.g. RECALL), press and hold
the button for over 1 second. This additional feature illuminates above or on the
left hand side of the appropriate keys.
Note:
The RANGE and EXIT buttons have only one additional feature.
Button
Description
Access Method
Range feature: Exit AUTO and enter MANUAL
ranging. In MANUAL, select next input range.
EXIT to return to AUTO. AUTO is default.
Press the button once.
Testing resistance signal from calibrator:
When testing resistance signal from calibrator,
it is necessary to press this button to change
the maximum display to 4000 counts but the
accuracy remains unchanged.
Press and hold the button
while turning on the meter.
Setup feature: Access Setup selections, the
display shows “SET”. In the Setup mode,
each press of SETUP button steps to the next
selection.
Press and hold the button for
more than 1 second.
Store feature: Store the current measurement
value. Press EXIT to exit.
Press the button once.
Recall feature: Recall the stored value. Press
EXIT to exit the Recall feature.
Press and hold the button for
more than 1 second.
Setup feature: In Setup, press to select OFF at
the selection of HIGH and LOW.
Press the button once after
entering Setup mode.
Hold feature: Press HOLD to freeze the
displayed value. Press EXIT to release the
display.
Peak Hold feature: Press to access Peak
Hold feature, the primary display shows PEAK
HOLD. Press EXIT to exit.
Press the button once.
Press and hold the button for
over 1 second.
In Setup, each press to select the digit you
want to edit.
In Recall, press to enable SEND feature
In Store, press to toggle between clearing all
the stored reading or start storing reading from
the current index number.
Press the button once after
entering Setup or Recall or
Store mode.
Steps to perform Peak Hold function:-
Peak Value : True RMS Value (Sinewave).
Peak Value is a half of Peak-to-Peak Value.
Input first, then press down
Peak Hold button.
Press EXIT button to quit the
function. If measuring high
voltage first, and then low
voltage, Peak Hold needs to
be reset.
RANGE
HOLD
STORE