TM
TM
Page <5>
V1.0
25/03/22
Newark.com/exclusive-brands
Farnell.com/exclusive-brands
Element14.com/exclusive-brands
10. DC
DC measurement
11. True RMS
TrueRMS measurement
12. +System Digit and Simulation Bar Measurement of reading value
13.
LPF measurement
14. INRUSH
INRUSH current measurement
15.
Buzzing on-off measurement
16.
Diode measurement
17. Zero
AC current gear ZERO
18. Max, Min
Maximum and minimum value measurement
19.
Relative measurement
20. Manual
Manual range
21. Auto
Auto Range
22. Measurement unit :
V
Voltage unit: Volt
A
Current unit: Ampere
Ω, kΩ, MΩ
Resistance unit: Ω, kΩ, MΩ
nF, µF, mF
Capacitance unit: nF, µF, mF
Hz, kHz, MHz
Frequency unit: Hz, kHz, MHz
°C, °F
Temperature unit: °C,°F
7. Key Function
1. SELECT/CLEAR
Select position by a short press.
With a long press, LCD will display “CLR” symbol, clear stored data record, and then “CLR” symbol disappears, MEM stored
number becomes 0.
2. RANGE/▲
While in data recording mode, enter the manual measurement mode by a short press of the RANGEbutton and change the
manual range. After a long press of the RANGE button, the unit will switch to manual ranging.
While under the data recording recall mode, you can view the stored data upward by pressing this key.
3. MAX/MIN/STORE
With a press on the key, enter MAX/MIN standby mode, LCD will display “----” ; after the second press, LCD will display “MAX”
to enter the maximum value measurement mode, after the third press, LCD will display “MIN” to enter the minimum value
measurement mode. Under non-standby mode, record the current measurement data with a long press on the key.
4. REL/▲
While in the data recording mode (except during DC Current function), enter the relative measurement mode with a short
press. The main display will show the measured value-basic value; the right display will show the basic value. Press again
