5
Voltage or Current channel setting
•
Press the adjusting control of either Channel 1 or 2 and the corresponding digital
readout will start blinking.
•
Rotate the contol to increase or decrease the voltage or current displayed on the
digital readout.
Adjusting Voltage on Channel 3
•
Press the Channel 3 button for 2 seconds until the current set voltage setting LED
illuminates.
•
Pressing repeatedly cycles through the 2.5V, 3.3V and 5V with corresponding LED
illuminating.to indicate the setting.
•
To enter Parallel mode, press and hold the PARA button. The PARA LED on the
display will illuminate to confirm the setting.
•
Initially default master channel is channel 2 with channel 1 as slave and shielded.
•
Press the ON/OFF button to switch the output on or off.
•
Connection terminals are shown in the diagram below.
VOLTAGE OR CURRENT MODE
