large primary display will show output voltage. With no load connected,
the Amperage will read zero. Once a load is connected, the Amperage
drawn by the load will be displayed on the lower Amp digits.
LCD, push
OUTPUT
button again to disengage the output.
2. Charge mode
Observe the warnings & safety precautions before installing and operating the
charger. Check battery condition, clean battery poles. Secure the battery charger
in a well ventilated place, make sure the mounting surface is flat and without soft
covering material or loose paper sheet. The air intake is at the left side and air
outlet at the right side. Make sure both intake and outlet are not blocked. Never
place charger on top of battery. Before connecting or disconnecting the charging
cable, unplug AC cord from the mains.
Charging Steps
First connect the Red battery clamp to the battery Po Pole.
Then connect the Black battery clamp to the Negative
– Pole of the battery.
Make sure all the connections are secured, double check on the correct polarity.
When charging automotive batteries:
With negative ground vehicles, the positive battery terminal should be connected
first. Then make the negative connection via the car chassis, away from the
battery, any fuel lines or other sources of combustion.
Then connect the charger to the AC power source.
After charging, disconnect the battery charger from the AC power source, Then
remove the chassis connection and then the battery connection.
Please ensure clamps are tightly connected to chassis and positive terminal to
prevent voltage drop and potential dangerous arcing.
2.1. Battery Voltage Setting
2.11. Switch on the power supply.
2.12. Push the
CHARGE
button to open the charging setting and
light the
CHARGE
button.
2.13. Push the
V/A
button, The value position is flickering of voltage
setting area.
2.14. Push the
UP
button the change the settings (12V or 24v).
2.2. Battery Ah setting
2.21. Push the
V/A
button, The value position is flickering of Current
setting area.
2.22. Push the
SHIFT
button to move the cursors.
2.23. Push the
UP
or
DOWN
button the change the settings (10Ah-120Ah).
2.3. Output Switch
Once the proper charge mode is set, press the
OUTPUT
button to turn on the
output and begin charging. This will initiate the automatic charging function.
2.USB mode
The USB ports are suitable for both android mobile phone and IOS phone,
with automatic check function. Push and light the
USB
button. Push and light the
OUTPUT
button to activate output mode.
SPECIFICATIONS
