Tendercare Ltd
Tilt and Fold Wheelbase Workshop Manual
Document No. Tilt & Fold Wheelbase workshop
manual v 2
Authority. Quality Controller
Authorised by
J Adams
Page
12 of 16
September 2010
8mm Bolt
Outer Frame
Nylon
Spacer
Metal Guide
Inner Frame
Large Lock Nut
Gas Strut
Plain Washer
M8 Nyloc Nut
LOWER MOUNTING COMPONENTS
4)
Remove the upper mounting bolt using a
10mm spanner and 4mm Hexagon Key.
Make sure you take note of the position of
the components as you remove them.
Remove the gas strut from the wheelbase.
5)
Loosen the locknut holding the operating
catch assembly to the shaft of the gas strut
using a 13mm spanner. Unscrew the
operating catch.
(see picture opposite).
7.4.2
Re-assembly
1)
Screw lock nut onto the new gas strut.
2)
Screw the gas strut onto the operating lever assembly until the operating lever is almost
but not quite touching the operating pin that extends from the gas strut.
3)
Tighten the lock nut against the release operating lever housing.