Ten-Haaft CARO Digital MA, Руководство по эксплуатации, Страница: 59 / 147

59
E
Sat Mouse - Control without remote control
The two keys on the satellite mouse (see graphic on this page below) allow the
following basic functions of the receiver to be controlled without the remote
control:
When in stand-by mode, a brief press on both keys switches the system back on.
If the receiver is in the Stand-by mode “energy saving”, it can only be restarted
by these keys both keys.
Another control element is the master switch on the front of the receiver. In po-
sition „0“ or „OFF“ the complete system is disconnected from the vehicle‘s power
supply. The switch must be in position „I“ or „ON“ for the system to operate.
Should the system no longer respond to commands, set the master switch to „0“
for approx. 10 seconds and then back to „I“ to reboot the operating software of the
receiver.
Change to the next channel in the channel list
Change to the previous channel in the channel list
Pressing both keys briefl y at the same time toggles between RADIO and TV mode.
Pressing both keys longer will cause the antenna to retract und the system to switch off.
This corresponds to pressing the red stand-by key (ON/OFF) on the remote control.
Satellite-mouse connector (RJ-45)
Remote-control receiver
Left satellite-mouse key
Right satellite-mouse key
Display 1
4
2
5
3
1
2
3
4
5