STEP 1 - BASE SETUP
Setup is now complete!
Only 1 processor (Base B) is used
for tandem/split setup.
For help installing the Tempur-Pedic
®
Sleeptracker
®
app, information can also be found at :
https://www.sleeptracker.com/getapp/tempur
U.S.: 1-844-309-3598
Canada: 1-800-887-4321
Mexico: 01-722-273-1810
a. Remove bases from packaging. Position bases to align HEAD/FOOT
ends the same direction. Note A/B position for the following steps.*
b. Locate printed materials (Base B only)*
c. Install legs
d. Connect power to base(s)
e. Insert remote batteries
f. Place units on their side with bottom towards each other for ease of
connections in step 2.*
STEP 2 SYNC CORD INSTALL (BASE A&B)
STEP 4 SLEEPTRACKER
®
PROCESSOR SETUP (BASE A ONLY)
STEP 5 SLEEPTRACKER
®
PROCESSOR SETUP (BASE B ONLY)
STEP 6 SLEEPTRACKER
®
APP SETUP (BASE B ONLY)
a. Disconnect male Battery
Backup Box Cable from female
Sleeptracker
®
Smart Cable.
a. Disconnect Sleeptracker
®
Sensor
Cable from Base A Sleeptracker
®
Processor.
a. Connect Base A Sleeptracker
®
Sensor Cable to Base B
Sleeptracker
®
Processor.
a. Test all functions on remote.
b. Connect male Sync Cord to
female Sleeptracker
®
Smart
Cable.
b. Route Sleeptracker
®
Sensor
cable through rubber conduit
and under Base A and B frames.
b. Route Base A Sleeptracker
®
Sensor
Cable through rubber conduit.
b. For Customer APP setup,
provide APP Setup Card from
printed materials (Base B card
only*).
c. Connect male Battery Backup
Box cable to female Sync Cord.
Discard additional sync cord,
only 1 is required.
d. Position bases back on their
legs to complete the remaining
steps. Assemble mattress
retainer bars and connecting
straps.
c. Disconnect Base A Sleeptracker
®
Processor from USB Extension
Cable.
c. Call Tempur-Pedic Customer
Service for delivery confirmation.
ERGO EXTEND
TM
+ SLEEPTRACKER
®
SYSTEM
SLEEPTRACKER
®
ERGO
TM
AND ERGO EXTEND
TM
TWIN LONG/SPLIT CA KING 2 UNIT SETUP
REFER TO IMAGES BELOW FOR STEPS 2-6 FOR SLEEPTRACKER
®
SETUP
Control box
USB
Extension
Cable
USB Ports
Underbed Light
USB Ports
Massage
Motor
Sleeptracker
®
Sensor
HEAD END
*Split Unit setup reference. Base A is
on right side.
Sleeptracker
®
Smart Cable
Underbed
Light
Battery
Backup Box
Head
Motor
APP Setup
Card
Sync Cord
Connecting
Strap
Foot
Motor
Massage
Motor
FOOT END
Sleeptracker
®
Processor
ERGO
TM
+ SLEEPTRACKER
®
SYSTEM
Underbed
Light
STEP 3 SLEEPTRACKER
®
SENSOR INSTAL (BASE A&B)
a. Remove Sleeptracker
®
Sensor
from twist ties.
b. Insert Sleeptracker
®
Sensor into
pocket.
c. Secure pocket to velcro strip
under head deck.
