Cyclone User Manual
72
Mounting the Projector
Projector Mounting - Landscape
Pull out the projector tray and place the
projector in position.
Align the projector, including any adjustment of
the projector feet.
Place one projector clamp around each of the
projector feet.
Use the carriage bolts, washers and nuts
provided to secure the clamps to the tray.
Tip: if you need to remove the projector for
service, remove the two clamps nearest you,
leaving the opposite clamps in place. When you
replace the projector it will be in the same
location as before.
Projector Clamp
M8 KEPS Nut
M8 Washer
Projector Clamp
Projector Tray
M8 x 20 Carriage
Bolt
NOTE: the projector
clamps should face
inward, with the V-
shaped opening
towards the middle of
the tray.
User Interface (Tacit
and Zen models only)
