SX5T Location and Installation
The SX5T comes with a standard spike antenna (TNC)
- see Figure 7
. For optimal signal strength,
choose a location that is above ground and as close to windows (or exterior walls) as possible
- see
Figure 8
. Place the unit where you receive the best signal strength possible. (Cellular signal strength
is displayed by the Received Signal Strength Indicator [RSSI] LEDs on the unit - see
LED Status
Indicators
on page 6 for more information.)
1.
Connect the antenna to the terminal
-
see Figure 7
.
2.
Finger-tighten the antenna. Do not over-tighten the antenna.
Wall Mounting
1.
Mark two hole locations 85 mm (3-5/16 inches) vertically apart and drill two holes into the wall.
2.
Install the screws (not supplied) into the wall, leaving a gap (approximately 3 mm (1/8 inch))
between screw head and wall.
3.
Align the mounting holes with the screws and mount the SX5T onto the screws -
see Figures 9
and 10
.
Figure 8 –
Typical SX5T installations.
Wall Mount
Table Mount
GPS Brackets
Figure 7 –
SX5T antenna connection.
Spike
antenna
TNC Antenna
Connector
Phonecell
®
SX5T CDMA
4
User Manual
Figure 9 –
SX5T mounting holes.
Mounting Holes
85 mm (3 5/16”)
Figure 10 –
Mount the SX5T onto the screws.
