SX4e TDMA 800
•
SX4e Tri-Mode
7
Technical Manual
HOW TO SET UP YOUR PHONE NUMBER
Your SX4e has been designed for easy setup and installation. You can program the Phonecell SX4e
with an ordinary tone-dial (DTMF) telephone, which is sometimes referred to as a POTS (Plain Old
Telephone Service) phone. Note: This programming mode is not accessible while you're in a call.
Before you begin programming, connect the antenna, plug in the power, and connect a tone-dial
(DTMF) telephone.
1) Pick up the POTS telephone handset and listen for a tone (either a steady dial tone or a beeping
no-service tone).
2)
Press:
#
*
0
*
1 2 3 4 4 3 2 1 #
The tone will change to a different, steady "Programming" tone and the bottom LED indicator on
the Phonecell will blink alternately RED and GREEN to indicate that you're in programming
mode. You now have two minutes to start the programming steps.
3)
Press
:
#
*
1
*
<MIN> #
This key sequence is used to enter your 10-digit telephone number (Mobile Identification
Number, or MIN). If you enter the number incorrectly, you'll hear 3 short tones followed by the
programming tone. If correct, you'll hear the programming tone again. If the MIN phone number
value is not 10 digits, it is considered invalid and the FWT will not update or store this value; the
currently stored value will remain.
4)
Press
:
#
*
5
*
<SID> #
This key sequence is used to enter the 1- to 5-digit System Identifier, or SID. This information
identifies your cellular service company. If you enter the SID incorrectly, you'll hear three short
tones followed by the programming tone; if correct, you'll hear the programming tone again. If
the SID value is not in the range of 0 to 32,767, it is considered invalid. The factory default is
69
.
5)
Press
:
#
*
4
*
<paging channel> #
This key sequence is used to set up your 1- to 4-digit initial paging channel. When you turn on
your Phonecell, this channel helps the service provider find you-and vice-versa. If the paging
channel is not in the range of 1 to 1023, it is considered invalid. Channels 800 to 990 are invalid.
The factory default channel setting is
333.
6)
Press
:
#
*
7
*
<band order> #
This key sequence is used to enter the band order. The band order value is a series of digits
between 1 and 2 (1 and 8 for Tri-Mode model) that must be at least 1 digit and not more than 2
digits (8 digits for Tri-Mode model) long. The following table describes the relationship between
the band order digits and EIA/TIA-136 system/band assignment:
Band Order Digits
EIA/TIA-136
1
System A (800 MHz)
2
System B (800 MHz)
3
Band A (1900 MHz)
4
Band B (1900 MHz)
5
Band C (1900 MHz)
6
Band D (1900 MHz)
7
Band E (1900 MHz)
8
Band F (1900 MHZ)
The factory default is
12
for the TDMA 800 model and
34125678
for the Tri-Mode model.
7) Hang up the phone. The flashing LED indicator will become solid GREEN. Phone Number Setup
is complete.
TDMA 800 model
Digital
Tri-Mode
model
