Telular PHONECELL SX4e GSM, Руководство пользователя, Страница: 15 / 50

Step 2. Plug In Your Telephone
SX4e GSM 1900
14
U
SER
M
ANUAL
Phone Cord
To Fax Port
To Phone Port
Figure 7: Dual Port
To Fax Machine
To Phone(s)
Phone Cord
The Phonecell SX4e lets you connect up to a 5 REN telephone load into a
cellular network. Follow the steps below for quick installation.
Connect Your Telephone
Dual-Jack Operation
The Phonecell SX4e may be operated in either
dual-jack or single-jack mode. The factory default
is the
dual- jack mode. In dual-jack operation, for
outgoing calls, the first jack to seize the line (go
off-hook) will disconnect the other jack. The other
jack will remain disconnected until the first jack
goes back on-hook. For incoming calls, voice
calls will be routed to the Phone voice jack and
fax calls will be routed to the Fax jack.
See How
to Set A Single Jack Option, to change program-
ming to single jack operation.
1) Locate the modular line port on your
phone and plug in one end of a standard
phone cord.
2) Connect the other end of the cord to the
telephone port
(marked PHONE) on the side
of your Phonecell SX4e - see Figure 7 .
NOTE: An RJ-11 connector will fit into the
Phone port.
NOTE: The Phonecell SX4e does not
support direct computer modem (data)
operation through the Phone port or Fax
port. It also does not support the phone
through the fax port.
3) Locate the modular line port on
your fax machine and plug in one end of a
standard phone cord.
4) Connect the other end of the cord
to the
fax port (To the Left of the Phone
port) on the side of your Phonecell SX4e.
Single-Jack Operation
The analog fax jack can be disabled leaving
only the telephone jack operational (single-jack
operation). In single-jack operation, voice calls
can be placed and received normally if a tele-
phone is connected. If a fax is connected,
incoming analog fax calls can be received
normally, but to place outbound fax calls using
the voice jack, a bypass sequence must be
used as a prefix in the dialed telephone number.