ModemUSB/H7.2
Quick Start Guide v0.2
3
Connecting to the PC
1.
Insert the SIM card into modem as indicated near the SIM card slot. Make sure, the SIM card is pushed in
properly.
Notice: Modem should be unplugged from the PC whenever you are inserting or replacing the SIM card!
When modem is inserted into PC, it is strictly advised not to remove or replace SIM card, failing to observe this
procedure will result in an unpredictable behavior of your PC and Modem.
2.
Plug the modem into your PC and wait until the operating system detects and assigns the needed drivers. This
process may take up to some minutes, and will be finished after popup window with the notification that your
hardware installed properly and ready to use appears.
3.
Double click the Modem Control Tool USB H7.2 icon on your desktop
:
SETTING UP AN INTERNET CONNECTION
Set up sequence
Screenshots
1.
On the main MCT screen click on the
Settings
→
Connection button.
2.
Enter the required parameters.
3.
Choose your preferred data bearer:
HSDPA or GPRS/EDGE. If GPRS is
chosen, the connection will be either
GPRS or EDGE – depending on the
service provided by your mobile
network operator.
4.
Click on the Update button and close
the Configuration tab.
GETTING CONNECTED TO THE INTERNET
Pay attention to “Status” LED which has to be ON if it is not ON – may be SIM card is absent or PIN code is not
entered. If the signal indicator shows low signal – try to place the “ModemUSB/H7.2” higher or closer to the window.
Set up sequence
Screenshots
1.
Click on the Connect button in main MCT menu.
Not connected:
Connected:
2.
If there is a problem while connecting to the network, the
Connection Troubleshoot menu will appear.
3.
First try to solve the problem by clicking Connection Settings
button; it will open the Connection Settings tab.
4.
If this does not help – close Modem Control Tool then unplug and
plug back the modem, as well try to restart your PC. If this does
not help – please contact your mobile network operator or local
distributor for more information
SENDING SMS
Notice: Please make sure that SMS service is supported by your operator and ensure that SMS centre number is entered.
Procedure for sending SMS:
1.
Run “Modem Control Tool” if it is closed.
2.
Click “SMS” (Short Messages Service).
3.
Enter the recipient’s phone number.
4.
Enter the text.
5.
Click “Send”.
Wait for a dialog box, which will inform you if SMS was successfully sent or not.
