40
9.5
Geofence zones settings and parameters
This chapter explains how to get all parameters for the first GeoFence zone (all ID numbers are
for the 1
st
zone). And at the end of the chapter (part 1.6.7) is presented a table with the IDs of all the
rest GeoFence zones.
GeoFence border width (ID=020)
GeoFence border thickness, measured in meters.
Minimum
value
Maximum
value
Recommended
value
Goes with (depends on) parameters
Value type
100
9999999
1000
GeoFence Zone #1 Configuration
U32
GeoFence Zone #1 Configuration Parameter (ID=030)
GeoFence Zone #1 Configuration is 1
st
zone basic settings parameter: GeoFence zone shape,
priority, zone entering event, zone-leaving event. There are two GeoFence zone shapes: circle,
rectangle. GeoFence Zone priority has eight levels (0 to 7). Parameter value is four bytes that have bit
encoded values.
0 bit
–
GeoFence zone shape
1-3 bits
–
GeoFence event priority
4 bit
–
Zone entering event
5 bit
–
Zone leaving event
6-31 bits reserved
Example:
Value to set: 51 (integer) is [M]00110011[L], where GeoFence Zone shape is Rectangular,
priority of 1, Zone entering event is enabled, Zone leaving event is enabled.
Minimum
value
Maximum
value
Recommende
d value
Goes with (depends on) parameters
Value type
0
-
-
GeoFence border width (ID=020)
U32
GeoFence x1 (ID=031)
Parameter has two meanings dependent on zone shape. If shape is rectangular, then ID=031 is
left down corner X coordinate in WGS. If shape is circle, then ID=31 is center of that circle X
coordinate in WGS.
Sample value: 25.30528
Minimum
value
Maximum
value
Recommended
value
Goes with (depends on) parameters
Value type
-180.0
180.0
-
GeoFence border width (ID=020)
GeoFence Zone #1 Configuration
Float
GeoFence y1 (ID=032)
Parameter has two meanings dependent on zone shape. If shape is rectangular, then ID=032 is
left down corner Y coordinate in WGS. If shape is circle, then ID=032 is center of that circle Y
coordinate in WGS.
