Telstra Elite, Руководство пользователя

Страница: 57 / 100

TELSTRA ELITE® GATEWAY USER GUIDE
57
Option Description
IP Address
Enter the IP address for the LAN interface
Subnet Mask
Enter the subnet mask for the LAN interface
Enable Internet Group
Management Protocol (IGMP)
Snooping
Enable by ticking the box Standard Mode: In standard mode,
multicast traffic will flood to all bridge ports when no client
subscribes to a multicast group.
Blocking Mode: In blocking mode, the multicast data traffic will
be blocked. When there are no client subscriptions to a multicast
group, it will not flood to the bridge ports.
Enable NAT
To enable/disable Network Address Translation (NAT, please refer
to 7.2 for NAT setting). By default NAT is enabled.
Enable UPnP
Tick the box to enable Universal Plug and Play
Dynamic Host Configuration
Protocol (DHCP) Server
Select enable DHCP server and enter your starting and ending IP
addresses and the lease time. This setting configures the gateway
to automatically assign IP, default gateway and DNS server
addresses to every DHCP client on your LAN
Static IP Lease List
To specify the IP address assigned through DHCP according to the
MAC address of the hosts connected to the gateway.
Enable DHCP Server Relay
To relay DHCP requests from the subnet with no DHCP server on it
to a DHCP server on other subnets. DHCP Server Relay is disabled
by default. To access enable DHCP relay, please un-tick NAT enable
first, that means to disable NAT first, and then press save button.
The enable DHCP server Relay option will then show up on the
same page as below:
Configure a second IP address by ticking the checkbox shown below and enter the following
information:
IP Address:
Enter the secondary IP address for the LAN interface.
Subnet Mask:
Enter the secondary subnet mask for the LAN interface.
NOTE: The Save button saves new settings to allow continued configuration, while the Save/Reboot button not only saves
new settings but also reboots the device to apply the new configuration (i.e. all new settings).