7
STAND FAN
TVP016210MD
1.
Unscrew the 7-shape Bolt from the Extension Pole. (Fig.1)
2.
Insert the extension pole into the chassis and tighten the
7-shape Bolt (Fig.2)
3.
From the extension pole loosen the height adjustment
ring and adjust the internal pole to the desired height. (Note:
If you can’t find the internal pole, it must inside the extension
pole. You can pull it out from the extension pole.) (Fig.3)
4.
To attach the head unit to the internal pole, loosen the
thumb screw on the bottom of the head unit. Place the
head unit on the internal pole and tighten the thumb screw
in alignment with the groove on the internal pole. (Fig.4)
CAUTION:
Height adjustment ring must be fully fastened before the assembly of the motor section to the
internal pole.
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the plastic nut counterclockwise
to remove both of them. Fix the rear grill to the motor then tighten the plastic nut again. (Fig. 5)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove of the blade. Turn the spinner
counterclockwise to tighten the blade. (Fig. 6)
3. Fasten the front grill and the rear grill by the grill clip and then tighten the fan grill locking screw and nut.
(Fig. 7)
ASSEMBLY OF CHASSIS & COLUMN UNIT
GRILL & FAN BLADE ASSEMBLY
Fig.5
Spinner
Tight
Loose
Plastic nut
Fig.6
Fig.7
