3. CONFIGURATION
After you have completed the Installation process of Section 2 successfully, please follow this section to configure
the settings of TWL-A11 to fit in with your environment. There are two utilities available, APUtility and SNMP
Manager. The former is used for local configuration, and the later is used for remote configuration.
3.1 APUtility
Before running APUtility, you have to make sure that:
1) Your PC connects to TWL-A11 through USB cable.
2) Your PC is running Windows 98, ME, 2000, or XP.
3) APUtility has been installed (refer to Section 2.6).
4) The AP’s driver has been installed (refer to Section 2.7).
5) The TWL-A11 is turned on.
Run the APUtility from “Start “, “Program”, “Access Point”, and ”APUtility”. A window “AP Utility Application” will be
displayed. Three buttons allow you to do the following functions.
1) “Configuration”:
Configure
the settings of the TWL-A11.
2) “Reset AP”: Reset the TWL-A11 and new configuration will take effect.
3) “Restore Default”: Restore the factory default values (refer to Section 6).
After you press the “Configuration” button, a window “AP Configuration” with the current settings will be displayed.
Press the “Get” button if you cannot receive the settings when the window is displayed. Clicking the listed identifier
and pressing the “Modify” button, a window will be popped up to allow you to input the new setting. The new settings
will be stored to the TWL-A11 only after you press the “Save” button. Press the “Exit” button when completed.
Please refer to Section 6 for the detailed information of each setting.
3.2 SNMP
Manager
Before running SNMP Manager, you have to make sure that:
1) The TWL-A11 is turned on and is connected to a LAN.
2) Your PC can access to the TWL-A11.
3) Your PC is running Windows 95, 98, ME, 2000, XP, or NT.
4) SNMP Manager has been installed (refer to Section 2.6).
Run the SNMP Manager from “Start “, “Program”, “Access Point”, and ”SNMP Manager”. A window “Access Point
SNMP Manager” will be displayed. If you have difficult in using it, please run from “Start “, “Program”, “TWL-A11”,
and ”SNMP Help” for detailed description about how to operate the SNMP Manager.
7
