8
SMS forwarding:
The device can forward incoming SMS messages to the phone number
configured with the
REPORT
command. After forwarding, it deletes the message
from the SIM card. If no phone number is set, the device will delete all incoming
messages without forwarding. A forwarded message looks as follows:
SMS forward from
the sender’s phone number: forwarded message
.
SMS sending limitation:
With this option, you can limit the number of SMS messages generated by the
inputs. When the configured limit is reached, the device will not send further SMS
messages generated by inputs until it receives a control call. By default, the
device allows sending only 1 SMS message per input between two control calls.
The next call will reset the message counter. You can change the limit or disable
the limitation function using the
SMSLIMIT
command.
Status query:
It is possible to request status report from the device in SMS. For a status query,
send the
PWD=password#STATUS?#
command in SMS to the phone number
of the device. The device will send an answer containing the actual status.
Example:
SIGNAL (0-10)=9
Mobile signal level on a 0 to 10 scale
INTYPE1=NO;
Type of input IN1 (NO or NC)
IN1=3;STATUS=IDLE
Sensitivity and status of input IN1 (5s, ALARM/IDLE)
INTYPE2=NC;
Type of input IN2 (NO or NC)
IN2=5;STATUS=ALARM
Sensitivity and status of input IN2 (5s, ALARM/IDLE)
REL1=3;STATUS=OFF
Activation interval and status of output 1 (ON/OFF)
REL2=FIX;STATUS=ON
Activation interval and status of output 2 (ON/OFF)
SMSLIM=1
Actual SMS limitation setting
Restoring the factory default settings (factory reset):
This process will restore the factory default settings, will reset the device
password, and will erase all users. For this, follow the steps below:
1.
Powered down the device and leave the SIM card installed.
2.
Close input IN1 (we suggest to use a toggle switch for this).
3.
Power up the device (LED signals: permanent green and flashing red)
4.
After 5 seconds LED lights are inverted (permanent red and flashing green)
5.
Open input IN1.
6.
After 5 seconds green and red flash together.
7.
Close input IN1 again and wait until the device connects to the mobile
network (this will be indicated by a continuous green LED flashing).
